3D mouse build.. tips?
Posted: Sat Jan 10, 2026 9:55 am
Hola
I’m building this model https://makerworld.com/models/2029436
The mouse uses a magnetometer to detect the movement of the magnets inserted into the knob. The magnetometer is connected to the control board using a quick connect cable.
There are 4 customizable buttons which also need to be wired to the control board.
I have printed the body and sourced the other parts, but am stuck on the wiring of the buttons. I haven’t done any work with wiring small components and don’t want to screw anything up.
The assembly video is in Italian and he kind of skips past the button wiring part, so any tips would be greatly appreciated.
I have attached a few images of the mouse opened up.
I’m building this model https://makerworld.com/models/2029436
The mouse uses a magnetometer to detect the movement of the magnets inserted into the knob. The magnetometer is connected to the control board using a quick connect cable.
There are 4 customizable buttons which also need to be wired to the control board.
I have printed the body and sourced the other parts, but am stuck on the wiring of the buttons. I haven’t done any work with wiring small components and don’t want to screw anything up.
The assembly video is in Italian and he kind of skips past the button wiring part, so any tips would be greatly appreciated.
I have attached a few images of the mouse opened up.
- IMG_2691.jpeg (1.05 MiB) Viewed 73 times
- IMG_2692.jpeg (1.16 MiB) Viewed 73 times
- IMG_2693.jpeg (2.03 MiB) Viewed 73 times